Hello Guest it is June 26, 2019, 05:00:26 AM

Author Topic: setting up second parallel port  (Read 12352 times)

0 Members and 1 Guest are viewing this topic.

Re: setting up second parallel port
« Reply #10 on: July 13, 2007, 06:15:09 AM »
Hi najnielkp

Yes all axis are up and running now thanx to  Chaoticone  (Brett)

In the end what we ended up doing was swapping the  paralell cables so that  my BOB and Z stepper got connected to the LPT1 port and the servos on LPT2

And of course change the settings in config/ports and pins/motor output.

The Drivers were installed by  Chaoticone , and we tried changing the adress for the second port into the settings.

Thanx again Brett

Best reg
Cory