Hello Guest it is June 27, 2019, 07:14:10 AM

Author Topic: Table freezes at end of X axis  (Read 599 times)

0 Members and 1 Guest are viewing this topic.

Table freezes at end of X axis
« on: January 05, 2018, 01:46:31 AM »
My table is freezing near X+ end of table when running G0 X0, or G1 X0. I hit E-stop and reset and can jog back with no problems. Table jogs full extents of table in both + and - directions. It only freezes when running code. Any ideas about possible settings that could be the culprit or any ideas I could try would be most appreciated!  Thanks for any ideas you might have!