Hello Guest it is August 19, 2019, 08:48:50 AM

Author Topic: Code stops at line 488  (Read 884 times)

0 Members and 1 Guest are viewing this topic.

Code stops at line 488
« on: January 06, 2018, 09:25:20 PM »
I'm ramping down to a depth on a slot and the code repeats x and y after line 488. I checked the flash drive I'm using and the code is all there. Also tried a different flash drive and the same result. Also tried reprogrammed only one of the three slots and also the same thing.


Sent from my XT1650 using Tapatalk

Offline Tweakie.CNC

*
  • *
  •  7,884 7,884
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Code stops at line 488
« Reply #1 on: January 07, 2018, 01:36:32 AM »
If you are using Mach3 in Demo mode then it is limited to ~500 lines of code.
The Mach3 license removes this limitation; http://www.machsupport.com/shop/mach3/

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
Re: Code stops at line 488
« Reply #2 on: January 07, 2018, 04:48:29 AM »
You should also not run from the flash drive but copy the file over to the hard drive.

Mike
We never have the time or money to do it right the first time, but we somehow manage to do it twice and then spend the money to get it right.