Third party software and hardware support forums. > dspMC/IP Motion Controller
Spindle analog signal
(1/1)
lcs226:
Having a mental lapse.
Hard drive crashed. Rebuild system but I cannot remember how I get the analog output to work for the spindle drive.
Spindle type - Analog (0-10v)
Spindle index - 7
Spindle scale - 100%
Using analog output 7 - Analog I/O port - J2 pin 19 and pin 17 (GND)
I get no voltage output from these pins.
What did I miss?
Thanks.
Vital System Support:
What is the plug-in and dspmc firmware version in your system?
lcs226:
Plug-in 2.01.72
Firmware 10.10 FPGA E901
Vital System Support:
please email the profile to support@vital... and we will check it. go to mach4 help menu and select package current profile and email it.
Vital System Support:
We found that the M3/M4/M5 macros in your profile were corrupt. once they were deleted from the macros folder, the spindle analog voltage started working.
Navigation
[0] Message Index
Go to full version