tldr: Jogging out of limit possible via "Override Limits" in Settings Screen, but not via "Limit Ovrd" Hardware Button
Hi,
I am presently building my mill and designing my control circuits ( not yet on machine but on the work table)
I am using a MachBob2 board with Mach3, and so far everything is as expected.
Except:
I have presently connected one switch as limit switch to an input (2/15, congigured as X++) and one switch as limit override (2/13, configured as Limit Ovrd)
When I jog an axis and trigger the limit switch, the motors come to an stop, the reset button blinks and the status says "Limit Switch triggered" and M1++ LED is on.
So far, so good.
If I activate "Override Limits" in the Settings Screen, I can reset and then jog, and when I switch off the limit switch, everything is back to normal.
Still so far, so good.
But: When I, instead of turning "Override Limits" on, switch on the switch connected to "Limit Ovrd", I can't reset and thus can't jog out of the limit condition.
Btw: yes, the LimitOV LED goes on when I switch on the "Limit Ovrd" switch.
Am I missing something here?
Sorry for the long post and thanks for any help!
Mike