Hello Guest it is April 19, 2024, 09:29:15 PM

Author Topic: New Computer port address issue  (Read 1422 times)

0 Members and 1 Guest are viewing this topic.

New Computer port address issue
« on: November 08, 2017, 06:00:49 AM »
Hi all,
Just upgraded to a new computer since a hard drive fail. hence no old XML or custom screen files.
Running Mach 3 on a 3 axis plasma table. Windows XP.
New computer didn't have a parallel port so running a card.
I didn't install the previous system so I am slowly learning what is required to make it work again.
I have managed to get the table running but the x axis is now outputting through the z channel and there is no z axis output anywhere.
I read the port address via the device manager.
E stop and plasma trigger relay output seem to be working.
All cabling and motors are working (I swapped them to a channel that was operating and they responded correctly)

Can anyone guide me where to look next ?

« Last Edit: November 08, 2017, 06:02:20 AM by mechfx »