Hello Guest it is March 28, 2024, 09:46:43 AM

Author Topic: Stop CV on Angles?  (Read 1783 times)

0 Members and 1 Guest are viewing this topic.

Stop CV on Angles?
« on: October 30, 2017, 04:19:19 PM »
Does Mach4 have anything similar to Stop CV On Angles like Mach3 had?

Thanks

Offline Chaoticone

*
  • *
  •  5,624 5,624
  • Precision Chaos
    • View Profile
Re: Stop CV on Angles?
« Reply #1 on: October 30, 2017, 11:03:16 PM »
Well, you can set the feed rate for any angle from 0 - 179 degrees. So, setting the speed for angles above 90 degrees to 0 would work.

The mcCVTuning wizard can populate the table for you giving the same result.

But, the mcCVTuningWizardV3 wizard in this topic is far better. It's smart enough to set the feed rate for angles to maintain a tolerance you enter in the wizard.

http://www.machsupport.com/forum/index.php/topic,35860.msg245507.html#msg245507
« Last Edit: October 30, 2017, 11:05:59 PM by Chaoticone »
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!
Re: Stop CV on Angles?
« Reply #2 on: October 31, 2017, 09:06:06 PM »
Your CVTuningWizard is awesome.  That should do the trick.  Thanks.

Offline Chaoticone

*
  • *
  •  5,624 5,624
  • Precision Chaos
    • View Profile
Re: Stop CV on Angles?
« Reply #3 on: November 01, 2017, 09:01:49 AM »
Thanks

No problem
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!