Hello Guest it is April 26, 2025, 01:17:50 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: UC100 Question  (Read 3563 times)

0 Members and 1 Guest are viewing this topic.

Offline Rarowe81

*
  • 2 2
UC100 Question
« on: October 17, 2017, 12:43:41 PM »
Hello All, I'm using a UC100 on a older laptop everything is working fine until I try and hook up an external monitor. The uc100 stops communicating as soon as its plugged to the port. I don't know if there is a conflict because the uc100 is emulating com 1 and if it can be changed in Mach 3? Any help would be appreciated.
Logged

Offline joeaverage

*
  • 7,600 7,600
Re: UC100 Question
« Reply #1 on: October 17, 2017, 01:54:21 PM »
Hi,
I'm sorry I can't help, I don't know the UC100 well enuf but CNCdrive support their products well. Either Tech support or forum.

Craig

https://www.cncdrive.com/
Logged
'I enjoy sex at 73.....I live at 71 so its not too far to walk.'

Offline ger21

*
  • *
  • 6,295 6,295
    • The CNC Woodworker
Re: UC100 Question
« Reply #2 on: October 17, 2017, 02:54:13 PM »
The UC100 is not "emulating" any ports. There's either some type of conflict, or the monitor is creating noise that is affecting the connection.
I'd try some ferrite beads on the USB cable, and/or a better cable.
Or, a different USB port.
Logged
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html

Offline Rarowe81

*
  • 2 2
Re: UC100 Question
« Reply #3 on: October 17, 2017, 04:26:45 PM »
Thanks for the feedback. I contacted CNC Drive and am waiting to hear back from them. I'd hoped it was a common problem that had a easy solution.
Logged
Pages: 1   Go Up
« previous next »