Hello Guest it is March 28, 2024, 06:24:32 AM

Author Topic: WITH THC ON MACHINE WILL NOT MOVE?  (Read 1400 times)

0 Members and 1 Guest are viewing this topic.

WITH THC ON MACHINE WILL NOT MOVE?
« on: September 03, 2017, 06:39:30 PM »
I'm sure its a setting (my dumba$$ changed). I can cut a part with no issues if I leave my THC off. If I turn it on cutting the same part the torch will come down turn on and turn on and not move. Does the same thing if I let the cut get half way through and turn it on, it'll come down and turn on and stop. Thanks in advance. Oh, its been working perfect not sure when it stopped working. I normally cut 16 ga small parts and leave it off most of the time until I start cutting thicker parts 3/16" and up.

Thanks