Hello Guest it is December 14, 2024, 05:29:29 AM

Author Topic: lathe will not thread  (Read 6831 times)

0 Members and 1 Guest are viewing this topic.

Offline fast89

*
  •  159 159
Re: lathe will not thread
« Reply #20 on: August 30, 2017, 07:01:08 PM »
G0 G40 G18 G80 G50 G90 G20 G64 G49
T0101
M3 S800
G00 X1.025
G00 Z1.00
G00 X1.00
G04 P2000.
G95
G76 X.95 Z.5 Q2. P.05 J.006 L0 H.015 I29. C.025 B.001 T0.
G0 G53 Z0 M5
M30
Re: lathe will not thread
« Reply #21 on: August 31, 2017, 06:59:36 AM »
Fast89, I was hoping to find something obvious there and didn't.  This is a puzzling problem.

Chris

Offline fast89

*
  •  159 159
Re: lathe will not thread
« Reply #22 on: August 31, 2017, 09:01:42 PM »
Well, figured it out, finally. It was an issue with either windows 7 or sata ssd. I wiped the hard drive and installed XP in ide mode and it is fine now. I don't think this had anything to do with mach3. Got everything back to running condition so tomorrow hopefully it will make its first good part.

Offline RICH

*
  • *
  •  7,427 7,427
Re: lathe will not thread
« Reply #23 on: September 01, 2017, 05:39:54 AM »
Glad you got it working.
May threading be with you! ::)

I envision a  :)  on your face.

RICH