Hello Guest it is May 17, 2024, 08:43:35 PM

Author Topic: "Use Master Command Pos" ???  (Read 4657 times)

0 Members and 1 Guest are viewing this topic.

"Use Master Command Pos" ???
« on: August 06, 2017, 04:15:44 PM »
On the "Axis setup" tab of the galil plugin for Mach3 there's some checkbox for each axis labeled "Use Master Command Pos". Those are not shown in the galil plugin manual (page 10) and I've searched everywhere but cannot find any info about this feature.

Well, my system is in fact working fine without that but I'm really curious about what those checkbox are doing. Anyone knows what this is for  ???

J-P
Re: "Use Master Command Pos" ???
« Reply #1 on: December 10, 2017, 03:45:08 PM »
Bumping this up as it is really bugging me...

Anyone know what this is for  ???  ???  ???

Re: "Use Master Command Pos" ???
« Reply #2 on: May 03, 2023, 09:57:30 PM »
Hi
Well some years later and I have the same question ??