Hello Guest it is April 18, 2024, 10:57:02 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: One side of X axis not in sync with opposite side. Jerky movement  (Read 1696 times)

0 Members and 1 Guest are viewing this topic.

Offline CSMG

*
  • 5 5
    • View Profile
One side of X axis not in sync with opposite side. Jerky movement
« on: July 11, 2017, 12:46:22 PM »
All, the X axis appears to be jerky. 1 side is smooth, opposite side is jerking trying to catch up. Unuseable at the moment, any ideas where to look?

Thank you
Mike
« Last Edit: July 11, 2017, 12:51:15 PM by CSMG »
Logged

Offline benjamint76

*
  • 22 22
    • View Profile
Re: One side of X axis not in sync with opposite side. Jerky movement
« Reply #1 on: July 11, 2017, 12:55:40 PM »
is it a mechanical issue or an electrical issue?

what is your setup?

has it been previously working?
Logged

Offline CSMG

*
  • 5 5
    • View Profile
Re: One side of X axis not in sync with opposite side. Jerky movement
« Reply #2 on: July 11, 2017, 04:19:11 PM »
Thanks for the reply. I don't know yet. This is the first time that this has happened.  I am going to take the coveres off and take the steppers off to see if they spin freely.   While it is on the machine and in place,  it is acting spuratic. 
I will see what is happening and write back.
Logged

Offline originalsigns

*
  • 10 10
    • View Profile
Re: One side of X axis not in sync with opposite side. Jerky movement
« Reply #3 on: July 18, 2017, 01:17:23 AM »
I'm having the same issues with my Y axis. I don't know much about my machine, but if I'm experimenting with my MOTOR TUNING to see if that helps. I wish i could be a better help, good luck!
Logged

Offline CSMG

*
  • 5 5
    • View Profile
Re: One side of X axis not in sync with opposite side. Jerky movement
« Reply #4 on: July 18, 2017, 08:03:32 AM »
I found the issue, one of the drivers on y was bad.
Logged
Pages: 1   Go Up
« previous next »