Hello
Guest
it is
March 29, 2024, 01:00:20 AM
Guest
Login
Register
Menu
Home
Help
Search
Calendar
Members
Members
View the memberlist
Search For Members
Login
Register
YouTube
Machsupport Forum
/
General CNC Chat
/
Show"N"Tell ( Your Machines)
/
Motors too hot! Any ideas?
« previous
next »
Print
Pages:
1
Go Down
Author
Topic: Motors too hot! Any ideas? (Read 3166 times)
0 Members and 1 Guest are viewing this topic.
discountBrainSurgery
40
Motors too hot! Any ideas?
«
on:
July 07, 2017, 09:34:42 PM »
This is a fresh build. Just got it running thanks to help from others. Today's question is: Why is X holding at about 105F while Y and Z are cooking at 160F? My router is probably not going to provide enough metal contact to sink it away. Thanks for any help.
https://www.dropbox.com/home?preview=too+hot.jpg
Logged
RICH
7,427
Re: Motors too hot! Any ideas?
«
Reply #1 on:
July 07, 2017, 10:24:42 PM »
Check / adjust the drive amp setting according to what the motor manufacturer recommends.
RICH
Logged
discountBrainSurgery
40
Re: Motors too hot! Any ideas?
«
Reply #2 on:
July 08, 2017, 11:26:11 AM »
Right you are my man! Thank you. I knew the dips were important, but I was sure I had set them all the same. In reality, the Y and the Z were all off by one switch. Thanks again.
Logged
Print
Pages:
1
Go Up
« previous
next »