Hello Guest it is July 22, 2024, 04:09:46 PM

Author Topic: limit override  (Read 2674 times)

0 Members and 1 Guest are viewing this topic.

Offline stirling

  • *
  •  2,188 2,188
  • UK
    • www.razordance.co.uk
limit override
« on: June 29, 2007, 03:36:14 PM »
I think I probably wandered off topic when I put this on the end of another post so here it is anew.

I upgraded from R1.84.002 to R2.00.065 and noticed that limit override (both manual and auto) doesn't appear to work. There's just no way to get off a limit (other than disabling them in ports n pins).

Has anyone else come accross this or have I set something up wrongly?

I've switched back to  R1.84.002 for the moment and everything is fine.


Re: limit override
« Reply #1 on: June 29, 2007, 03:51:13 PM »
Not 100% sure but I think I am using R2.00.65 on my mill and the Auto Limit Override works fine. If I remember I will check it out tomorrow when I go to the workshop.