Hello Guest it is December 02, 2024, 11:47:47 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Create feed hold with input leg 15  (Read 1921 times)

0 Members and 1 Guest are viewing this topic.

Offline CNCDK

*
  • 23 23
Create feed hold with input leg 15
« on: May 10, 2017, 04:45:34 PM »
I'm going to make feed team with pin 15
I choose OEM Trig # 2
Why does it still think there are limits and an alarm ???
What can I do ??

Logged

Offline olf20

*
  • 325 325
Re: Create feed hold with input leg 15
« Reply #1 on: May 11, 2017, 07:15:30 AM »
I'm not exactly sure what you are saying, but go to
config, inputs and disable each one till you find out
what is causing the stop.
Hope this helps.
olf20 / Bob
Logged
Mach3, Atlas Knee Mill, 4th Axis, VcarvePro, ESS, Super PID.
Been Heating with corn since 1998

Offline CNCDK

*
  • 23 23
Re: Create feed hold with input leg 15
« Reply #2 on: May 11, 2017, 08:09:40 AM »
Sorry ... I have not deleted pin 15 from an A axis
Logged
Pages: 1   Go Up
« previous next »