Hi there
I have two steppers for my Y axis, and it was working almost Ok, I had only occasional stalls.
I decided to change my gear on the steppers, so I replaced the 13 pitch or tooth Gear(pinion), with a 22 Pitch or tooth.
I am using 1600 per revolution for my resolution, and 22 tooth * by the 7 mm . 22*7=154 mm, Then I divide the 1600/154= 10.38
I entered this value for the step per unit. I get almost no movement, I tried the value of 90, with a very low speed of about 2000 mm and acceleration of 50. I get my best result, and it moves much much faster than 2000 mm/min. and it stops after few seconds of me relaxing the up or down arrow.
I should mention that for few hours, I tried all different kind of scenarios, But with out any real success, I just could not figure out its behavior.
Does any one have any explanation or recommendation for me?
Could it be that I have a lose connected wire? How can I check for my wiring? needless to say That all my wires are in E chain.
What is the best way to find out the best speed and acceleration for my machine? Knowing that motor tuning is not working properly For me at the time.
Also whenever it stalls it spears that the motor is not sitting properly on the Rack, It looks kind of lose. But when it is moving it appears that it is Ok. Is this a Normal behavior?
Regards
Jhonansaro