Hi Tweakie
Thanks again mate for your time and effort.
Followed your instructions to the letter but still the error persists.
At this point I should clarify this machine was only ever put together as a simulator and intro to CNC, being a Chinese Machine to start with I only purchased a cheap Chinese controller kit and motors, although I've upgraded the breakout board I think the problem lies in this cheap equipment. I've planned all along to either built or buy a more substantial CNC Router.
The question now is.
1: Persevere with the Chinese controller.
2: Cut my loses, build a recommended controller and fit motors from a reputable supplier.
3: Build or buy that more substantial machine.
I'm leaning towards 2 as I don't want to start a more substantial build without really winning on this one also I'd have something to learn/play on while I build and the experience I've gained so far outweighs the cost of this controller.
So if any of you would be kind enough to post links of controller builds, suppliers, videos or anything that would assist in putting a sure fire controller together that would be most appreciated.Thanks again for all your efforts.
Cheers Mick.