Hello,
I have two computers to do milling using Mach3.
Let me give them temporary names as PA and PB.
Both PA and PB are also running on Windows 7.
The problem is that the following menus are not working on
PA.
Completely no response. No window appears.
Config -> Motor Tuning
Function Cfg's -> Calibrate Spindle...
Function Cfg's -> ScrewMappingA common point is that these menus are
drawing graphs.
That must be the key.
But it's
OK on PB.
Of course I checked both registry settings.
No difference.
Of course I copied Mach3 including .xml and other files from PB to PA.
Still problem.
PA hardware must have no problem,
So what is the cause?
If someone noticed possible solution, please let me know.
Best Regards.