Mach Discussion > Finished Screens

3 Axis mill with ATC

(1/2) > >>

krsykes23:
Here is the recently updated screenset for my 3 Axis Mill.  The Offsets screen should really be in 'Work in Progress' but thought I'd share it here.

I have to add a few bits to this screen but quite pleased with the results.

Tweakie.CNC:
Very nice work.

Just a thought...
The Emergency Stop may be a bit misleading to the inexperienced as a software polled EStop should never be relied on in an Emergency. The only true 'Emergency Stop' physically disconnects power to all parts of the machine (and if applicable automatically applies any brakes, locks, etc.).

Tweakie.

krsykes23:
Point taken!  However, I don't think I've ever used the button as an actual e-stop in an emergency.  Merely for
resetting.  I have a physical e-stop next to the machine.

Tweakie.CNC:
Very nice looking machine as well - I think you have a set-up to be proud of there.

(Perhaps rename the on-screen button RESET ?  ;) )

Tweakie.

wmgeorge:
It needs a Reset, Cycle Start, Pause, Stop large buttons easy to see, and the Loading Code and etc does not need to be taking up so much screen.

Navigation

[0] Message Index

[#] Next page