Hello Guest it is December 06, 2019, 01:02:39 PM

Author Topic: Tuning Slaved Axes Motors  (Read 767 times)

0 Members and 1 Guest are viewing this topic.

Tuning Slaved Axes Motors
« on: January 04, 2017, 11:24:28 AM »
What is the procedure for tuning the two motors of a slaved axes? Do I tune each motor individually while unhooked from the axes? Or do I tune the motors while hooked up to the axes (gantry)? Should the velocity, acceleration, etc numbers (of the two identical motors) on the Motor Tuning Config pages be the same?

Thanks,

Mike

Offline Davek0974

*
  •  2,580 2,580
    • View Profile
    • DD Metal Products Ltd
Re: Tuning Slaved Axes Motors
« Reply #1 on: January 04, 2017, 03:15:19 PM »
The motors, drive settings, steps per, velocity and acceleration should all be identical really.

The setup should be tuned as one item so get the slaving working correct, set the steps per and tune from there.
Bridgeport Mill, Mach3 V062, CSMIO-IP/A controller, AC Servo Drives