Hello Guest it is March 29, 2024, 07:30:48 AM

Author Topic: Laser M10P1  (Read 16800 times)

0 Members and 1 Guest are viewing this topic.

Offline Snues

*
  •  16 16
    • View Profile
Re: Laser M10P1
« Reply #20 on: August 07, 2016, 01:44:55 PM »
Hey Tweakie,

i tried today the laser as we discussed with the paper... unfortunetaly there was no shot from the laser, even though the circuit works with the battery. With the button at the power adapter, a laser-shot is possible, so it should be a problem with the circuit. I took 2 pics of the wiring, may i ask you if you recognise any mistake?






Green = GND
Black = m10p1

Greetz Bernd
« Last Edit: August 07, 2016, 01:48:40 PM by Snues »

Offline Tweakie.CNC

*
  • *
  •  9,196 9,196
  • Super Kitty
    • View Profile
Re: Laser M10P1
« Reply #21 on: August 08, 2016, 01:34:59 AM »
Hi Bernd,

I can't say for certain but there does not appear to be any mistake with your wiring.

Obviously you need to set the PWM signal near maximum, the potentiometer to around 10%, turn on the spindle (M3) and apply the M11P1 command.

Tweakie.
PEACE