After installing a Pendant , the slow jog % do not work normally , and as the pendant are not always attached it's quite annoying
Removing the pendant and it's plug in do not help  ?   The % works fine with the pendant, but not without

Does anyone know if this slow jog % is in the XML file and if so "where" , or  any good advice on restoring the slow Jog % to work as normally

Thanks   

Mechman

Odd set of faults.
Don't bother trying to hack the XML - it was not meant to be user-friendly.
Instead check the keyboard assignments for the pendant and look on the Tab fly-out page for jog details.
Pendants do work, but you have to get the codes right.

Cheers
Roger

I removed the pendant plug-in , and reinstalled mach 3 ,

result absolutely no difference

I am going to create a new xml "setup file " like when Mach 3 was new and blank

I will post the result