Hello Guest it is May 21, 2019, 05:53:24 PM

Author Topic: CV Problems / Losing steps  (Read 7645 times)

0 Members and 1 Guest are viewing this topic.

Hood

*
Re: CV Problems / Losing steps
« Reply #20 on: June 04, 2007, 12:56:50 PM »
Ran it no problem here, have G202's which are 10 microstepping. I think I remember reading about the servo drives from Gecko that have the step pulse multiplier having similar problems but not the stepper drives, still worth doing a search though.
Hood
Re: CV Problems / Losing steps
« Reply #21 on: June 05, 2007, 04:32:19 PM »
Hi guys

Found this little gem after speaking to ART and John Prentice and doing my own little search.

http://finance.groups.yahoo.com/group/geckodrive/message/10642

This is exactly what my drive is displaying in that little engraving program.
I am sure a few people would be intersted in this that has bought any drive with the G901 in it.
I just don't understand why this information has not been widely available.
Needless to say i have ordered some opto couplers to replace the G901.

Regards
Mark
www.weardalecnccarving.co.uk

Hood

*
Re: CV Problems / Losing steps
« Reply #22 on: June 05, 2007, 05:20:38 PM »
I think thats the same problem I saw written in this forum about the servo drive, didnt realise the G212 used step multipliers.
 Glad that you have found your problem.

Hood