Hello Guest it is December 12, 2024, 08:51:57 PM

Author Topic: imach pendant sometimes locks up in single-step mode  (Read 13088 times)

0 Members and 1 Guest are viewing this topic.

imach pendant sometimes locks up in single-step mode
« on: June 15, 2019, 10:46:06 PM »
Hi.  I have an imach III P1A-S tied to Windows 10/64 running Mach 3.  For the most part it runs ok.
However, sometimes when I switch to the single step mode, it all locks up and no setting of the knobs can get control back.  What *does* work is toggling the EMO button in then back out (usually), moving to velocity control mode (V) and jiggling a stage around.  I do not have this mapped out precisely because too many combinations.  It might just be a timeout is necessary.

It also has the alarming tendency for the stage suddenly going into constant speed mode while jogging in single-step mode, which is a leap for the EMO button event!

I've also sent this to the VistaCNC support email.

thanks
Matt