Hello Guest it is April 20, 2021, 08:34:28 AM

Author Topic: Outputs  (Read 3599 times)

0 Members and 1 Guest are viewing this topic.

Re: Outputs
« Reply #10 on: October 18, 2016, 01:40:40 AM »
Hi Tweaky, we just purchased a new (original) license. To make sure that everything starts from scratch I deleted/uninstalled everything that to do with Mach3 from the laptop and downloaded it new from the Artsoft website and installed it. I installed only the profiles for Mill and Plasma. After that I unpacked the license. So where do I go from here? Thanks Karl

Offline Tweakie.CNC

  • *
  •  8,696 8,696
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Outputs
« Reply #11 on: October 18, 2016, 05:04:02 AM »
Hi Karl,

I am pleased to hear that you have purchase a genuine Mach3 license.
Follow your motion controller’s set-up procedure.
Copy your license file Mach1Lic.dat into the Mach3 folder.
Do not duplicate the pin numbers allocated to the 0 – 7 Outputs in your Outputs set-up.
For your Outputs 0 – 7 to drive anything (relay etc.) they need a power source as shown in the attached diagram.

Hope this helps.