I read in the manual at 5.6.6.4 "General Logic Config.. Column 4 " it reads "…….The Index pulse and the other inputs have independent settings". That's the word regarding Index Debounce. Wow, that's really profound :-)
Anyway, I added 1000 in the Debounce Interval box as Dave suggested, did a Ref All and it made all Home switches in turn and backed off each a bit but not far enough to clear/open any. But the 1000 addition made a difference - No flashing Reset as the the Ref All process finished with all three homes witches (sp) still triggered. Progress! I've tried setting the debounce, 1k per trial, up to 4000. Not sure if this increases the travel to getting off the switch. Or is it normal that it sits on the switch? Any problem otherwise if it remains on the switch? Also, what can a high 4000 setting cause otherwise?
Curiously I then jogged to the Z limit switch. Reset flashes. Status: "External E-Stop requested" Diag: M1 ++ Lim M2++ Lim M3-- Limit all 3 yellow. Same for the other two axes. That's probably normal. How do I get off the 3 switches?
Do I click "Mach3 can fix the setting changes for you"? If I agree, thought it might mess other parameters that have been configured. so I ended the session, closed Mach3 and manually backed off all switches.
Clearing a limit switch takes several resets repetitions: Jog one step,RESET, clear the reset, jog one step, RESET, clear Reset etc, etc till it clears the switch. Must be a better way?
Thanks,
Ya-But