Victory!!!
Well you were right. I got lucky and figured it out before I read your last post, lol. I was reading about my smooth stepper and apparently there are jumpers underneath my BOB that need jumped in order to provide power. After that I tried it wired as is and got nothing, then I tried swapping the wires on the drivers again, like you suggested and BAM!! motor movement. Played with motor tuning a bit and threw some basic code at it and it was a beautiful sight.
I have been working on this project off and on for 2 years and invested over $5,000 rebuilding my little G0704, adding double ballscrews, building motor mounts, one shot lube, treadmill motor conversion with belt drive. This is a pretty amazing feeling to finally get the darn motors moving. I feel like its all down hill from here.
Stephen, Thanks again for stepping up to the plate and pointing me in the right direction. Maybe someday I will have an opportunity to pay it forward.
-Tyson