Hello Guest it is March 28, 2024, 07:10:59 AM

Author Topic: Z plunging deeper after each retraction. Not mechanical  (Read 4052 times)

0 Members and 1 Guest are viewing this topic.

Re: Z plunging deeper after each retraction. Not mechanical
« Reply #10 on: July 23, 2016, 05:32:14 PM »
If that is being measured without the load of a tool and cutting forces then I think you are done, it isn't likely to get any better.
Re: Z plunging deeper after each retraction. Not mechanical
« Reply #11 on: July 23, 2016, 07:49:03 PM »
Gary,

You are probably right. I may not mess with the 1.8Kw - overkill and probably won't make a difference. It is just odd that a C2 accuracy screw is not running in the tolerance it should.

Thank you again my friend.


Gio