Hello Guest it is March 29, 2024, 08:40:04 AM

Author Topic: Z-Zero problem  (Read 1274 times)

0 Members and 1 Guest are viewing this topic.

Z-Zero problem
« on: July 07, 2016, 10:46:06 PM »
Using MACH 3 version R3.043.062 USB Smooth Stepper, PMDX 126 BOB and 134 Mother Board.  Since changing over to the smooth stepper I must load a cut file into Mach before I can Z-Zero the spindle or use any of the icons on the 2010 Screen Set.   Is there something I need to change in MACH or is this a Smooth Stepper issue?

Thanks
Bill I