Hello Guest it is December 10, 2019, 06:06:47 AM

Author Topic: After update to 4.1.65 Homing problems  (Read 2111 times)

0 Members and 1 Guest are viewing this topic.

Offline GerdS

*
  •  42 42
    • View Profile
After update to 4.1.65 Homing problems
« on: May 28, 2016, 01:57:42 PM »
I just updated my controller to new version 4.1.65.
But now the Homing function works not like before.
Unfortunally i killed my X Axis sensor.
It looks like the homing does not stop the motors immediately after the signal comes.
My X home switch is also the end switch therefore i have just a few mm for stop.
After downgrate to an earlier Firmware version all is Ok again.

Offline NeoTO

*
  •  504 504
    • View Profile
    • PoLabs
Re: After update to 4.1.65 Homing problems
« Reply #1 on: May 29, 2016, 02:30:39 AM »
Hi, Gerd

The update 4.1.65 will be pulled and a fix will be released immediately.
www.poscope.com home of PoKeys USB HID, IO, USB, Ethernet controler and PoScope USB PC oscilloscope

Offline GerdS

*
  •  42 42
    • View Profile
Re: After update to 4.1.65 Homing problems
« Reply #2 on: May 29, 2016, 05:39:10 AM »
Ok, fine.
Could you find a solution for the Motion step Overflow issue already. ?
If you need somebody for tests, i can do this for you.

Gerd

Offline NeoTO

*
  •  504 504
    • View Profile
    • PoLabs
Re: After update to 4.1.65 Homing problems
« Reply #3 on: May 29, 2016, 11:10:03 AM »
Unfortunately, we are still working on determining the cause for the steps overflow issue. I think we will have the fix soon.
www.poscope.com home of PoKeys USB HID, IO, USB, Ethernet controler and PoScope USB PC oscilloscope