Hi Guys,
I downloaded older version of Mach3, but do I have to go through the complete setup again, or how can I transfer all settings from original version? Delete original version?
Remember, I'm just an ol' cabinetmaker...
I switched mouse and Keyboard to side usb ports and they started working again, but the usb for mach3 motion controller, only worked in the side ports to start with.
The mouse and Keyboard were in the rear ports, and they are the ones giving me the problem, about every fifth or sixth time I use it? Could that be hardware or software?
How do I fix it?
I am using an Acer Aspire ZC-700G All in One, 64 bit, new computer, Windows 10, to run Mach3 USB. The HP I told you about earlier, I use for ArtCam Express. My Bad.
I appreciate your help,
JR