Hello Guest it is May 16, 2021, 05:45:46 PM

Author Topic: homemade cnc plasma not right  (Read 5158 times)

0 Members and 1 Guest are viewing this topic.

Re: homemade cnc plasma not right
« Reply #20 on: May 15, 2016, 11:09:49 PM »
Got a little more done today. water tank is in but just for looks , still has to be pressure tested.

Offline Hood

*
  •  25,838 25,838
  • Carnoustie, Scotland
    • View Profile
Re: homemade cnc plasma not right
« Reply #21 on: May 16, 2016, 03:17:51 AM »
Looking good, was considering a water table myself but decided to go with downdraught as I will be doing mainly Alu and Stainless.

Hood
Re: homemade cnc plasma not right
« Reply #22 on: May 19, 2016, 08:22:08 PM »
Finally got it off the fab table. I think I am going to change the electronics box so that it will fit under the water pan.