Hello Guest it is September 21, 2019, 01:56:22 PM

Author Topic: Direction change constant rate problem  (Read 1100 times)

0 Members and 1 Guest are viewing this topic.

Direction change constant rate problem
« on: April 03, 2016, 10:45:31 PM »
Hello, I noticed following behavior in Mach3 (explicit in slow speeds e.g. 1 step/sec):
When direction is changed (G01 X1, G01 X0) step rate is not constant - doubles on turnaround.
Can it be disabled?
Re: Direction change constant rate problem
« Reply #1 on: April 08, 2016, 05:10:01 AM »
Nobody? Other experience to achieve constant slow step rate without accel./decel. (mill profile)?