Hello Guest it is September 17, 2019, 05:39:59 PM

Author Topic: spindle control  (Read 4433 times)

0 Members and 1 Guest are viewing this topic.

Offline Tweakie.CNC

*
  • *
  •  7,905 7,905
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: spindle control
« Reply #10 on: April 05, 2016, 02:09:31 AM »
I no longer have an X4 to check the spindle set-up for direction control – perhaps someone else can help with this (this thread is old so it may be best to start a new topic asking the question).

In Config. / Ports & Pins / Spindle Setup you can specify a ‘Spin-Up Delay’ – Gcode execution is paused for this period of time to give your spindle time to get up to speed.

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.