Greetings All.
I've read up on this topic a LOT, tons of googling, Found a ton of info here, unfortunately, not the info I need to fix my problem.
Followed the wiring here.
http://www.homanndesigns.com/pdfs/EN010_V8.pdfThe relays work. The spindle indeed starts. However, the RPM shows 0 in Mach3 AND it cannot control the speed of the spindle. I can turn the POT and it adjusts just fine, but if I try to change the speed in Mach3, nothing happens. I have setup everything according to Port/Pins info found here. Set up my pulley and all that.
Thoughts?