Hello Guest it is September 28, 2023, 05:36:08 PM

Author Topic: Well I had stepper control  (Read 3430 times)

0 Members and 1 Guest are viewing this topic.

Well I had stepper control
« on: November 16, 2015, 06:05:57 PM »
Well between yesterday and today something has changed.  I no longer have stepper motor control.  I'm using Mach 3 licensed, and was setting up all the parameters.  I had motor response when I shut down last night and now this morning I can't get them to respond.  I uninstalled and reinstalled Mach 3, used back up config settings from earlier in the day to no avail. 
I know this isn't much to go on, but I don't know what else to do.

Re: Well I had stepper control
« Reply #1 on: November 24, 2015, 05:04:15 PM »
I sent the control box in, apparently it had a bad capacitor in the
reset circuit.