I recently installed Mach3 with the Candcnc breakout board to an old Dyna 2800 mill. Using the Sherline mode, it seems to run fine with the original Dyna steppers and drivers (much to my amazement, I might add!).
The only thing that isn't working (so far!) is the Feed Hold button. When I hit the button on the screen during program execution, I get the "Note: Cycle pause in effect.. No jogging or Reverse!!" message in the status box, but the program continues to run normally.
The "Stop" buttons works perfectly.
Is there something I could have overlooked in the set up that would cause this?
Thanks,
ventuseu