Author Topic: Mach3 Simple Thread Wizard only wants to cut in one direction. HELP!  (Read 3867 times)

0 Members and 1 Guest are viewing this topic.

Offline eatsteelnotbutter

  • Active Member
  • Posts: 8
    • View Profile
Re: Mach3 Simple Thread Wizard only wants to cut in one direction. HELP!
« Reply #10 on: January 26, 2016, 09:28:48 PM »
YOU GUYS ARE AWESOME!

It was the software as I was beginning to suspect.  Updated to the latest version, installed the 32 bit key, set my Surestepper rev... it ran perfectly right out of the chute!  Couldn't believe it.  Lathe runs flawlessly.  Hopefully my 4 axis mill also still runs flawlessly.  I'll check that tomorrow night.  Right now I'm having way too much fun playing with canned cycles.

Thanks again!  I really do appreciate it!

-Damon

Offline Overloaded

  • Global Moderator
  • *
  • Posts: 4,763
    • View Profile
Re: Mach3 Simple Thread Wizard only wants to cut in one direction. HELP!
« Reply #11 on: January 26, 2016, 10:55:47 PM »
Hot DAMN !!!!!
 I love it when a plan comes together !

Carry on my friend,

Russ