I am trying to do a large v carve project. I have my flat depth set at -.0800” so the z axis should never go below that. (-.0800”)
The program starts to run and as it does the z keeps getting deeper and deeper. this gets worst as the program runs. I stopped the gcode and the last z command says -.0800 but the DRO is reading -.0982 WTF???
Mach3 ver. R3.043.066 Hicon plug in ver 1.36.7 Firmware 2.42
N295640G1X74.6586Y20.9157Z-0.0800
N295650G1X74.6696Y20.9204
N295660G1X74.6836Y20.9283
N295670G1X74.6960Y20.9370
N295680G1X74.7042Y20.9444
N295690G1X74.7112Y20.9521
N295700G1X74.7168Y20.9599
Look at the gcode below you can see the code showing a depth of -.0800 but the DRO
Is showing -.0982 WTF??? I have attached the gcode as well
Mach3 ver. R3.043.066 Hicon plug in ver 1.36.7 Firmware 2.42