Hello Guest it is September 15, 2019, 01:40:35 PM

Author Topic: Defining material, 0/0 point, etc.  (Read 2562 times)

0 Members and 1 Guest are viewing this topic.

Re: Defining material, 0/0 point, etc.
« Reply #10 on: November 23, 2015, 06:50:35 PM »
So, Tweakie - I was pretty happy to find out the "Feed Rate" is right on the main page on F-Engrave. Nice program.
Thanks again.
Frank

Offline Tweakie.CNC

*
  • *
  •  7,903 7,903
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Defining material, 0/0 point, etc.
« Reply #11 on: November 24, 2015, 01:50:52 AM »
Sorry guys I will try not to F***** in the future.  ;D

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.