Hello Guest it is April 18, 2019, 01:06:48 PM

Author Topic: Sticky Axis  (Read 655 times)

0 Members and 1 Guest are viewing this topic.

Sticky Axis
« on: October 28, 2015, 11:46:10 PM »
I just re-installed my Mach3 system. All working fine, however when I cycle Mach3 it sets the X, Y and Z axes to zero, requiring recalibration.

In its previous incarnation the Z axis setting was sticky - whatever it was set to prior to Mach3 being cycled would survive.

Clearly I've not set something to allow Mach3 to "remember" the Z axis value. Problem is, what?