Hi All I am New Here and am just getting Started I built a machine and used Mach 3 in Demo Mode which worked fine until i hit the line limit.
So I decided to make the plunge and purchased mach 4. I am now setting it up and can't get the machine to move when i click the Ref all home. In the Diagnostic page it says it's homing but none of the axis move. I have to hit stop to allow the axis to once again to move using the jog buttons. Am I missing something in the pins setup. Please Help!!
Can you think of things that should be checked.
Please make a list I could check.
Thanks all
Ill post a picture of my homemade machine when I get a chance.