Gen Notes:
USing V.076 I cannot access the different layers by clicking on them from the screen they highlight but do not change. I can change the layers from the properties bar ok
Multipass, do we really need to return to and from safe z on each pass?
Leadin? What is the proper size for a lead in? Is it a ratio of the tool diameter? Can we have the default based on a ratio of the tool diam?
Tool table, can we have a reference popup window that accesses Mach's tool table for a reference(this is LAZYCAM correct I get too lazy to go find the tool table catalog for mach(;-) )
Drill holes, If in the tool settings it calls for a step that is less than the max depth can we have a peck drill instead of a straight drill.
COuld we have an option to create another layer of the drill layer to use for a tapping layer, with the input to set up mach for
tapping Gcode wise(G95,Feed per rev,Etc., or a spot drill layer , etc.
Good so far (;-) TP
Gcode utility, could we have a simple utility to reoder the line numbers that get mixed up from cutting a pasting and editing the Gcode file.