Hello Guest it is March 29, 2024, 04:46:29 AM

Author Topic: Cannot select a couple of items  (Read 3888 times)

0 Members and 1 Guest are viewing this topic.

Cannot select a couple of items
« on: December 05, 2015, 01:13:47 PM »
First of all - thanks for developing MachScreen and supporting it - for free!  I know what it takes to write and support software so I appreciate your work.

I am writing a simple screen for my touch screen monitor.  All is going quite well.  But I have one nagging problem.

I have a couple of labels and a button that I cannot select individually. When I try to select one nothing happens, it is as if the button/label are not there.  However they all work fine in Mach3.   I can select them with "Select All". Clicking unlock for mouse move does not have an effect.  The controls are listed on the overview page and do not appear to be different than other controls of the same type.  

Suggestions?

I have attached the screenset and images.  The errant controls are ResetFRO button, FRO% label and FRO (IPM) label
Re: Cannot select a couple of items
« Reply #1 on: December 05, 2015, 02:12:37 PM »
Nevermind.  I found that by selecting all, cutting all the controls, then pasting them back on they came back.
Re: Cannot select a couple of items
« Reply #2 on: December 05, 2015, 03:32:10 PM »
Hi,

do you use single or multiple selection? What controls cannot be selected?


Klaus
The brain isn't a soap, it doesn't shrink when used.

Offline Greolt

*
  •  956 956
    • View Profile
Re: Cannot select a couple of items
« Reply #3 on: December 05, 2015, 04:49:07 PM »
Anything on page zero will show on all pages but can only be edited while on page zero.