Hello Guest it is May 19, 2024, 08:06:16 AM

Author Topic: Delay Time  (Read 1712 times)

0 Members and 1 Guest are viewing this topic.

Delay Time
« on: August 17, 2015, 11:43:50 AM »
 ;D Hi, i was scrolling through some Threads looking for another solution when i bumped into this((( delaying the running of code until spindle motor is up to speed))) of course i did not note the link, >:(  up to now i have edited the code and added (G4 P15) into the code just under motor start up line.but the thread says i can do this by putting a fixed delay time into MACH3

How do i do this in general config or some other place in mach?????? :-[  some help is greatfully received ::)
« Last Edit: August 17, 2015, 11:58:22 AM by cncezee »

Offline rdean

  •  94 94
    • View Profile
Re: Delay Time
« Reply #1 on: August 17, 2015, 05:22:06 PM »
Try "Ports & Pins" then "Spindle Setup"  under config.