Hi all

I know this has been asked before on older posts.  Most of the links are now dead and there must be a  better product out by now
have servo amplifiers that have a +- 10 volt input. Need to convert a step direction  from mach mill to the +-10 Volt to operate the servo amps.
used Skyco pixies on another project long time ago  but they are long gone  now.
any ideas what is the best.

Thanks  DAS

Larken makes the Step2Linear boards.
http://www.viperservo.com/

There are also a few motion controllers that can control analog servos. CS Labs, Vital Systems and Dynomotion all make them.