Hello Guest it is September 25, 2023, 12:29:34 PM

Author Topic: Lathe spindle problem  (Read 1355 times)

0 Members and 1 Guest are viewing this topic.

Lathe spindle problem
« on: July 29, 2015, 09:16:53 AM »
on a 3 axis lathe (x,z)linear axis one rotary axis and it is used as spindle for lathe

when I configure the 3 axis c axis (port 1 step pin 3 and direction pin 4) it works well

but when  I configure as spindle  same pins on motor outputs tab and set Use spindle motor output &&step/dir Motor on spindle setup tab , computer doesn't send any pulse or direction signal to servo

what can be the problem