Hello Guest it is November 29, 2022, 06:42:35 AM

Author Topic: Edge Probe with G31  (Read 1558 times)

0 Members and 1 Guest are viewing this topic.

Edge Probe with G31
« on: March 15, 2015, 11:29:29 PM »
When probing an edge using G31 I assume the probe must have some give so as not to damage the probe or edge before the motion stops.  Typically how much give is needed?  I'm using a Taig mill.

Any good plans to make one?  If the amount of give is just a few thou might a short length of piano wire set in epoxy, or other insulating material, work?


Offline dude1

  •  1,253 1,253
    • View Profile
Re: Edge Probe with G31
« Reply #1 on: March 16, 2015, 12:23:03 AM »

Broken link fixed
« Last Edit: March 16, 2015, 12:30:36 AM by Chaoticone »