Hello Guest it is March 28, 2024, 09:58:52 AM

Author Topic: is there anybody that can use pocket tool ?  (Read 2951 times)

0 Members and 1 Guest are viewing this topic.

is there anybody that can use pocket tool ?
« on: April 12, 2007, 08:24:18 AM »
Hi all
I am licenced user I have been trying to use pocket tool for 2 days but I cant do it.

is there anybody that can use pocket tool ?
Ahmet
from TURKEY
Re: is there anybody that can use pocket tool ?
« Reply #1 on: April 12, 2007, 12:09:27 PM »
It does not work for me either.  It may be that the code is not done yet.
Re: is there anybody that can use pocket tool ?
« Reply #2 on: April 12, 2007, 01:45:08 PM »
Please be kind and upload the DXF that you are trying to offset and tell us the amount that you are trying to offset.
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: is there anybody that can use pocket tool ?
« Reply #3 on: April 12, 2007, 01:57:32 PM »
Brian,

Can you send me your email address.  I can email the file to you.  Although there is nothing special about it.  A plate with three 0.4" holes.   A 0.25" diameter end mill, so the offset is 0.25", though I have tried smaller offsets with the same results.
« Last Edit: April 12, 2007, 03:42:10 PM by split63 »
Re: is there anybody that can use pocket tool ?
« Reply #4 on: April 12, 2007, 05:01:23 PM »
you will see there is a icon under the dog that is barking ... click on that and you will mail me :)

Thanks
Brian
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com