Hello Guest it is October 14, 2019, 12:55:18 PM

Author Topic: Safer connection from Mach3 to X200 VFD?  (Read 6352 times)

0 Members and 1 Guest are viewing this topic.

Re: Safer connection from Mach3 to X200 VFD?
« Reply #30 on: February 20, 2015, 08:19:50 AM »
I use stop--> Run from Here --> Start all the time... never an issue. If you use Stop and then Start (not using "Run from here" before the start) you will lose some position.